MaxLinear has introduced Jeju (MxL77904), a custom multiphase power management IC (PMIC) aimed at DSP-based 1.6T pluggable optical modules used in AI infrastructure networks. The part targets the low-voltage, high-current power rails associated with advanced optical PAM4 DSPs, where converter efficiency and transient behavior directly show up as module heat and power headroom.
Jeju is built for 3 nm and 4 nm CMOS optical PAM4 DSPs and is designed to deliver up to 95% peak efficiency. MaxLinear also claims up to 0.5 W power savings per 1.6T PAM4 DSP versus conventional PMICs. The company says the efficiency focus is intended to reduce module power consumption and heat dissipation, with downstream impacts on thermal management cost and manufacturing yield. Jeju is optimized for MaxLinear’s Rushmore 1.6T PAM4 DSP, and is also intended to support DSP-based 1.6T module designs more broadly.
As DSP process nodes move to 2 nm, 3 nm, and 4 nm, supply voltages trend below 1 V while current demand climbs, which can push conventional PMICs away from their best efficiency points. In dense OSFP and QSFP-DD form factors, that penalty becomes practical quickly: a few tenths of a watt can be the difference between staying within a module’s thermal design envelope or throttling, de-rating, or revisiting heatsinking and airflow assumptions.
The MxL77904 uses MaxLinear’s Constant On-Time (COT) controller architecture, which the company says delivers fast transient response using ceramic output capacitors without external loop compensation. Jeju also includes Dynamic Voltage Scaling (DVS) controlled via I²C registers or GPIO. It supports configurable phase topologies—4+0, 3+1, 2+1+1, and 1+1+1+1—with up to 5 A per phase.
Other stated features include 0.5% typical DC output-voltage accuracy, programmable switching frequency from 600 kHz to 4 MHz, and remote voltage sensing. The device comes in a 54-ball WLCSP package, and integrates protection functions including over-voltage, under-voltage, over-current, negative-current, short-circuit, and over-temperature protection.
“Jeju is purpose-built for the low-voltage, high-current requirements of advanced optical DSPs, delivering up to 0.5W savings per DSP in a 1.6T optical module,” said Amit D. Bavisi, Ph.D., Senior Vice President and General Manager of MaxLinear’s Analog Mixed-Signal Business Unit. “We are engaging with lead optical-module customers to support early evaluation and platform development.”
Jeju (MxL77904) is expected to sample to customers in February 2027. More information is available at maxlinear.com/MxL77904.
Source: MaxLinear
















